set gslb vServer-GSLB-1-MIR ENABLED

What will the Citrix ADC appliance send when the above command is executed?

A. The Remote GSLB service as the first record in the response and adds the remaining active services as additional records

B. The Local GSLB service as the first record in the response and adds the remaining active services as additional records

C. Only the best GSLB service in the response

D. The best global server load balancing (GSLB) service as the first record in the response, and the remaining active services as additional records

Which mode on a Citrix ADC can a Citrix Administrator utilize to avoid asymmetrical packet flows and multiple route/ARP lookups?

A. MAC-based forwarding (MBF)

B. Use Subnet IP (USNIP)

C. Layer 3

D. Layer 2

Scenario: A Junior Citrix Administrator needs to create a content switching vServer on a Citrix ADC high availability (HA) pair. The NSIP addresses are 192.168.20.10 and 192.168.20.11. The junior administrator connects to NSIP address

192.168.20.10 and saves the changes.

The following day, a Senior Citrix Administrator tests the new content switching vServer, but it is NOT working. The senior administrator connects to the HA pair and discovers that everything the junior administrator configured is NOT visible.

Why has the Citrix ADC lost the newly added configurations?

A. The junior administrator made the changes and did NOT force a failover to save the configuration.

B. The junior administrator connected to the NSIP of the secondary Citrix ADC in the HA pair.

C. Both Citrix ADCs in the HA pair restarted overnight.

D. The Citrix ADC appliances have different firmware versions.

A Citrix Administrator needs to protect the HTTP backend server type without actually removing the header. Which rewrite action type can the administrator apply to the Citrix ADC configuration to accomplish this?

A. REPLACE

B. CORRUPT_HTTP_HEADER

C. REPLACE_HTTP_REQ

D. REPLACE_ALL

Users are experiencing resets from the intranet server website, which is load balanced through the Citrix ADC. Which Citrix ADC tool can a Citrix Administrator use to troubleshoot the reset issue?

A. View the newnslog from the command line interface (CLI) to look for packet resets from the Citrix ADC.

B. Use the nslog to look for packet resets on the Citrix ADC.

C. Take a packet trace with nstrace and analyze with Wireshark.

D. Look in the event viewer for packet resets from the Citrix ADC

Scenario: While performing a disaster recovery test, a Citrix Administrator decides to failover the Citrix ADC high availability (HA) pair appliances. The administrator notices that the failover is NOT working as expected, and the secondary Citrix ADC is NOT taking over as primary. The administrator suspects that networking issues may be causing the failure.

What could be the cause of this issue?

A. HA monitoring is enabled on an interface of the secondary node that shows as ENABLED, DOWN.

B. The Independent Network Configuration (INC) mode is enabled on the primary node.

C. HA monitoring is enabled on a disabled interface of the primary node.

D. HA heartbeats are only seen on some enabled interfaces of the secondary node.

If a policy evaluates as_________________ a Citrix ADC performs the action assigned to the ____________ condition and stops further policy evaluation.

A. TRUE; FALSE

B. UNDEFINED; TRUE

C. UNDEFINED; FALSE

D. UNDEFINED; UNDEFINED

Scenario: The Citrix Administrator of a Linux environment needs to load balance the web servers. Due to budget constraints, the administrator is NOT able to implement a full-scale solution. What can the administrator purchase and install to load balance the webservers?

A. Citrix ADC MPX

B. Citrix ADC VPX

C. Citrix ADC SDX

D. Citrix ADC CPX

A Citrix Administrator needs to configure a rate-limiting policy setting DNS requests to a threshold of 1,000 per second. Which command does the administrator need to run to correctly configure this policy?

A. HTTP.REQ.LIMIT()

B. SYS.CHECK.LIMIT()

C. SYS.CHECK.LIMIT() || CONNECTION.IP.LIMIT()

D. SYS.CHECK.LIMIT() || HTTP.REQ.LIMIT()

In a global server load balancing (GSLB) active-active environment, the connection proxy is used as the site persistence method. What is used to source the traffic when the connection is proxied?

A. Subnet IP (SNIP)

B. LDNS IP Address

C. Client source IP

D. Virtual IP (VIP)