When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)

A. Controller disconnection behavior

B. Captive Portal strength

C. Simultaneous logins

D. Firewall and traffic shaping

E. RADIUS for splash page settings

In an organization that uses the Co-Termination licensing model, which two operations enable licenses to be applied? (Choose two.)

A. Renew the Dashboard license.

B. License a network.

C. License more devices.

D. Call Meraki support.

E. Wait for the devices to auto-renew.

What are two roles of the network and device tags in a Dashboard? (Choose two.)

A. Tags enable administrators to configure a combination of network and device specific tags to create summary reports filtered for specific devices across multiple networks.

B. Network tags can be used to assign networks to separate Auto VPN domains in an Organization with many networks.

C. Network tags can be used to simplify the assignment of network-level permissions in an Organization with many networks.

D. Device tags can be used to simplify the assignment of device-level permissions in an Organization with many administrators.

E. Device tags can be assigned to MR APs to influence the gateway selection for repeaters in a mesh wireless network.

Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?

A. starts on the secondary MX appliance and then occurs on the primary MX appliance

B. starts on both MX appliances at the same time and then reboots both appliances after traffic on the primary MX appliance ceases

C. starts on both MX appliances at the same time and then immediately reboots both appliances

D. starts on the primary MX appliance and then occurs on the secondary MX appliance

Where should a network admin navigate to investigate wireless mesh information between Meraki APs?

A. Wireless > Monitor > Access Points > AP > RF

B. Wireless > Configure > Radio Settings

C. Wireless > Monitor > Wireless Health

D. Wireless > Monitor > RF Spectrum

A Cisco Meraki MV camera is monitoring an office and its field of vision currently captures work desks and employee computer screens. However, recording employee computer screens is prohibited by local regulation. Which feature in Dashboard can be used to preserve the current position of the camera while also meeting regulation requirements?

A. zone exclusion

B. privacy window

C. area or interest

D. sensor crop

E. restricted mode

Which information is used to calculate whether a WAN link has high usage?

A. data under Security and SD WAN > Appliance Status > Uplink > Live Data

B. total historical throughput of an uplink

C. total number of devices that are actively passing traffic

D. value under Security and SD WAN > SD WAN and Traffic Shaping > Uplink Configuration

Which configuration step is necessary when automatic updating is required of iOS apps provisioned through Systems Manager that are found in the App Store?

A. No configuration step is necessary; automatic updating is the default behavior.

B. Configure automatic updating of iOS devices in the Meraki installed profile.

C. Create a security policy that enables automatic updates.

D. Create a profile with automatic update enabled and apply it to iOS devices.

DRAG DROP

Drag and drop the descriptions from the left onto the corresponding MX operation mode on the right.

Select and Place:

DRAG DROP

Drag and drop the settings from the left into the boxes on the right to indicate if the setting will be cloned or not cloned using the Cisco Meraki MS switch cloning feature.

Select and Place: