Which Ethernet interface on an RPA is used for management?

A. eth0

B. eth1

C. eth2

D. eth3

A company recently acquired a new DR site and requires their production data to be replicated to this DR site.

What is an important consideration about the RecoverPoint out-of-band architecture?

A. Performance on the production site is not impacted.

B. Site-to-site connectivity needs to be based on Fibre Channel.

C. Maximum asynchronous replication speed is 400 MBps.

D. Maximum synchronous replication speed is 400 Mbps.

In the Recovery tab of Unisphere for RecoverPoint, which option is used to temporarily mount an image?

A. Test a Copy

B. Enable Image Access

C. Manage Recovery

D. Enable Direct Access

A company with a DR site connected with a 2 Gbps FC link has three vRPAs at each site. They are experiencing High Load events, although the FC link is not fully utilized.

What would be the best solution to get the FC link utilization up as high as possible while mitigating those events?

A. Replace the vRPAs with physical RPAs and start using a Distributed Consistency Group

B. Add two more vRPAs to the Primary site and divide the Consistency Group into four segments

C. Divide the Consistency Group into two segments and start using Distributed Consistency Groups

D. Add two RPAs to the Primary site as well as the secondary site

When registering the RPA with a VNX to enable a VNX splitter for RecoverPoint, what failover mode must be set on the VNX?

A. 1

B. 2

C. 3

D. 4

You are implementing a VPLEX 4-engine Metro with a RecoverPoint cluster at one site. You need to add all VPLEX splitters to the RecoverPoint cluster.

How many splitters need to be registered?

A. 1

B. 2

C. 4

D. 8

What does the MetroPoint feature provide?

A. Local protection on both sides of a VPLEX Metro

B. Local protection on one side of a VPLEX Metro

C. Protection for only the active copy of a VPLEX distributed device

D. Simplified manual switchover

Which authentication method is available for use between the vRPA and the VNX when configuring RecoverPoint/SE with Deployment Manager?

A. CHAP

B. iSNS

C. LDAP

D. RSA

You are adding a new vRPA to a cluster using the Add New RPAs wizard in Deployment Manager. SAN diagnostics fail and you cannot add the RPA. Pings to the vRPA and VNX iSCSI ports are returned successfully.

What is most likely the cause for this connection problem?

A. CHAP authentication not correct

B. vRPA iSCSI ports MTU set to a number lower than 9000

C. Default gateway setting for RPA iSCSI ports not correct

D. Wrong IP version set on vRPA iSCSI ports

What are the three potential bottlenecks that can cause a RecoverPoint Consistency Group to go into High Load?

A. WAN bandwidth, remote storage performance, and RPA performance

B. RPA performance, splitter overhead, and SAN latency

C. WAN bandwidth, SAN latency, and host performance

D. Host performance, splitter overhead, and WAN bandwidth