Why is it considered a best practice to use tools such as HP Smart Update Manager (SUM) and Virtual Connect Support Utility (VCSU) to deploy firmware components?

A. These tools check the dependencies and limitations.

B. The tools are compatible with all versions of firmware.

C. These are the only tools that can be used to work with Virtual Connect Enterprise Utility (VCEU).

D. These tools are version compatible by design.

Which Virtual Connect module enables FCoE or iSCSI connectivity for the c-class server blades?

A. VC1/10Gb-F

B. VC-FC 8/24

C. VC Flex-10

D. VC FlexFabric

Which statements are true about Agentless Management? (Select two.)

A. Agentless Management Service is installed as a daemon in HP-UX.

B. Agentless Management is installed using Ignite UX.

C. Agentless Management is only supported on Integrity Blades.

D. The Agentless Management Service provides OS information to ilo

E. Agentless Management is only supported on Gen8 servers.

What can be used to reboot the Active or Standby Onboard Administrator (OA) module?

A. ASR implemented on the OA level

B. enclosure link-down port

C. enclosure Reset button at the rear of the enclosure

D. Insight Display

What must be used to update Virtual Connect firmware above version 3.0x when VCEM is used and managing other domains?

A. VCM

B. HP SUM Offline

C. VCSU

D. HP FDT

What is the correct UEFI shell command to display a list of drivers on an HP Integrity BL860c i2 Server Blade?

A. drivers

B. map

C. drvdiag

D. drvcfg

Refer to the exhibit below.

A customer reports that Insight Display shows five NICs installed in a half-height server blade, but a connection to only two of them can be established. What could cause this to happen?

A. The NICs and interconnect modules are running different firmware revisions.

B. The NICs and iLO share the same interface.

C. Some interconnect modules are powered off.

D. The NICs are multifunction cards and also operate in iSCSI mode.

Which information can you find on Insight Display?

A. server memory errors

B. server mezzanine errors

C. server hard drive errors

D. server Smart Array

When connected to the c7000 or c3000 enclosure service port how does a Windows-based laptop configured for DHCP acquire its IP address?

A. The laptop will receive an address in the 192.168.x.x address range from the DHCP server within the enclosure.

B. The laptop will receive an address in the 169.254.x.x address range from the DHCP server within the enclosure.

C. The laptop will timeout waiting for a DHCP server to respond and will assign itself an address in the 169.254.x.x address range.

D. The laptop will timeout waiting for a DHCP server to respond and must have an address manually assigned in the same subnet as the enclosure.

You are preparing to replace a system board on a BL680c. What should you do first?

A. Remove the disk drive cage.

B. Remove the cover.

C. Remove the processors.

D. Connect the ESD strap.