Which Intelligent Management Center (IMC) group role allows an administrator to manage networking devices, but cannot add new IMC administrative users?

A. Operator

B. Administrator

C. Manager

D. Maintainer

Which HP switch supports nine switches in an IRF topology?

A. 5120-SI

B. 5820

C. 7500

D. 12500

Refer to the exhibit.

A network administrator needs to configure link aggregation using static LACP on Switch-A, which is an HP Comware switch. Which configuration accomplishes this goal?

A. Option A

B. Option B

C. Option C

D. Option D

Which Access Point (AP) type corresponds to HP MSM autonomous operational mode?

A. Thin

B. Fat

C. Modal

D. Fit

Which VLAN port type is only supported by HP Comware switches?

A. access

B. voice

C. trunk

D. hybrid

Refer to the network exhibit.

All of the switches in the exhibit are configured as follows:

Config name =";Region!'

Revision #= 1

Instance 1=VLANs 10.12

lnstance2 = VLANs11,13

1ST instance = VLANs 1-9.14-4094

Currently, onlyVLANs 1,10,11,12, and 13 exist on the four switches. A network administrator adds VLAN 15 to Switch_C. How is the topology affected by this change?

A.

Spanning tree recalculates, with load sharing not in effect to Switch_C.

B.

Spanning tree recalculates, with load sharing still in effect to Switch_C.

C.

A loop now exits involving Switch_C.

D.

No topology changes occur with spanning tree.

Refer to the exhibit.

A network administrator is managing the configuration files on an HP Provision switch and executes the commands shown in the exhibit. What is the probable cause of the error message when the network administrator tries to copy the file?

A. The flash memory in the switch is full and supports no more files.

B. The copy command should only be used to manage operating systems.

C. No empty configuration memory slots exist on the switch.

D. The copy command contains a syntax error.

A network administrator executes this command on an HP switch:

Provision (config)# vlan 11 untag Al

The network administrator immediately realizes that the port that was specified in the command was the wrong port. Port A1 should remain in its original VLAN, VLAN 1. Which command should the network administrator execute to undo the misconfiguration?

A. vlan 11 tagged Al

B. vlan 1 tagged Al

C. vlan 1 untag Al

D. no vlan 11 untag Al

A network administrator is using Intelligent Management Center (IMC). Which protocol must the networkadministrator configure to correctly identify HP devices when performing auto discovery?

A. telnet

B. LLDP

C. SSH

D. SNMP

A network administrator has an HP Comware switch that is configured with OSPF. The network administrator views the routing table and sees that a default route was learned from an OSPF neighbor (10.1.1.1). However, the network administrator wants to override this action and use a different neighbor (10.1.1 2) for the default route.

The network administrator configures this command:

[Comware] ip route-static 0.0.0.0 0 10.1.1.2

After configuring the command, the network administrator examines the routing table and notices that the original neighbor's default route is still in the routing table, but the static route is missing.

What is the cause of this problem?

A. OSPF routes have a lower precedence value

B. The ip default-gateway command must be used when creating a default route

C. Only one routing protocol can be operational on a Comware device

D. The static route has a syntax mistake