Click the Exhibit button.

In the diagram shown, a portset is created on controller 1 with the command:

controller1>portset create -f ntapportset 0b. This portset is bound to the igroup with all the initiators in it.How many paths can host 1 see to a LUN on controller 1?

A. six paths

B. four paths

C. eight paths

D. two paths

Which command on a NetApp storage controller will display the average service time on a FC target port basis every five seconds?

A. sysstat -i 5

B. sysstat -f 5

C. fcp stats -i 5

D. lun stats -i 5

What are two functions of iSCSI access lists? (Choose two.)

A. control the network interfaces on the storage system that an initiator can access

B. define authentication parameters(CHAP)

C. limit the number of network interfaces advertised by the storage system

D. define MPIO behavior

Which command do you use on a Brocade switch to view all defined zone configuration information?

A. cfgActvShow

B. show zone

C. cfgshow

D. switchshow

Which command do you use to see the rate of change between two successive Snapshot copies in a flexible volume in Data ONTAP?

A. snap diff

B. snap calculate

C. snap delta

D. snap space

Which three tasks should be completed as part of the site preparation for install? (Choose three.)

A. plan zoning configuration

B. verify equipment move path

C. determine aggregate layout

D. verify power drops in the equipment location

E. make contact with data center personnel

Which three does NetApp support for iSCSI with Microsoft Windows solutions? (Choose three.)

A. VLANs

B. Jumbo frames

C. NIC teaming

D. Microsoft MCS

E. NIC trunking

Which statement is NOT true regarding NetApp Snapshots of VMware ESX datastores?

A. A NetApp Snapshot captures the entire FlexVol including information NOT associated with VMDKs.

B. For VMDKs on VMFS datastores, to restore a specific VMDK requires a copy from the NetApp Snapshot to the datastore.

C. NetApp Snapshots can be employed to backup VMFS, NFS, or RDM datastores.

D. NetApp Snapshots are instantaneous, so they always produce an application consistent image

Which statement correctly describes ALUA concepts on NetApp Storage solutions?

A. ALUA is a LUN attribute that is set.

B. ALUA deals with Fibre Channel LUNs and is NOT appropriate for iSCSI.

C. ALUA can be used for Windows 2003 and Windows 2008 disk management.

D. A LUN can be mapped to an ALUA-enabled igroup and a non-ALUA-enabled igroup.

Which three steps are required to make a LUN visible to a NPIV-supported VM? (Choose three.)

A. Map a LUN to the igroup containing the NPIV WWPNs.

B. Configure a matching NPIV port on the NetApp controller.

C. Set options.npiv.enable to TRUE on the NetApp controller.

D. Create a zone containing NetApp target ports and NPIV WWPNs.

E. Create an igroup on the NetApp controller containing the NPIV WWPNs.