A company is using an SC4020 array and the storage administrator wants to expand the available capacity by adding 92, 3.5" disk drives. Which expansion enclosure(s) can be used to meet the demand?

A. 1x SC280 drive bay

B. 2x SC180 drive bays

C. 4x SC220 drive bays

D. 8x SC200 drive bays

Which method can be used to identify the server HBA WWN?

A. Brocade Web Tools "Port Admin" tab

B. Dell Storage Manager Data Collector

C. Dell Storage Manager Client

D. QConverge Console GUI

Based on the exhibit, a customer is using Virtual Port Mode. If the primary path for the controller on the "left" is disconnected while running an IOmeter test for a volume owned by the "left" controller, will the system survive failover?

A. Yes, Virtual Port Mode will failover the I/O through the other available paths.

B. No, Virtual Port Mode does not support port failover.

C. No, the system does not have reserved paths to perform failover.

D. Yes, the reserved path will be active and I/O will continue.

Why should Legacy Port Mode be selected rather than Virtual Port Mode on an SC Series storage array?

A. Virtual Port Mode requires NPIV support

B. Legacy Port Mode is easier to set up and more reliable

C. Virtual Port Mode is difficult to set up

D. Virtual Port Mode does not support ALUA

In an SC Series environment, which Fibre Channel zoning method is more flexible?

A. Port

B. Single Initiator/Multi-Target

C. Single Initiator/Single Target

D. WWN

Refer to the Exhibit.

You are testing failover from a host perspective. The host has been configured in a "Failover Only MPIO" configuration. When running IOmeter if the Data Path 2 cable from the host is disconnected, will the host survive the failover?

A. No; Failover MPIO is configured for only Data Path 1

B. No; IOmeter is sending I/O only on one path

C. Yes; the server has Data Path 1 connected to both controllers

D. Yes; Failover MPIO should failover

An alert for a failed disk is visible under the alerts tab. Where would someone navigate to, in Unisphere Central for SC Series to identify the failed drive and have a graphical representation showing where in the enclosure the failed drive is located?

A. System menu, Hardware submenu, Disks

B. Hardware tab, then Enclosure in navigation tree

C. Storage menu, Disks

D. Storage tab, then Disks in the navigation tree

In Storage Manager, what should you do to have the Create Server wizard recognize an HBA properly?

A. Verify the iSCSI initiator has a valid IP address, subnet and gateway

B. Ensure that iSCSI traffic is on a separate dedicated network

C. Add the FC WWNN when asked in the wizard

D. Ensure that proper FC zoning and the HBA is configured

You are required to install twenty-four (24) 3.5" 12 Gb disks on a deployed system. Which disk enclosure would support this?

A. SC420

B. SC400

C. SCv320

D. SC460

Which Live Volume Requirement or Best Practice is necessary for disaster recovery?

A. Primary and Secondary Storage Centers configured in Unisphere for SC Series

B. QoS defined on the Primary system

C. Licensed Live Volume on secondary Storage Center

D. Fibre Channel or iSCSI with a round trip latency of less than 10 ms