A company intends to deploy VxRail with support for GPU cards. Which type of VxRail nodes should be recommended?

A. E Series

B. V Series

C. G Series

D. P Series

Which integrated backup solution is included with VxRail at no additional cost?

A. Dell EMC Data Protection Suite

B. VMware vSphere Data Protection

C. VMware VM Snapshots

D. Dell EMC NetWorker

Based on the exhibit, which interfaces should be used to reset the node through the Mobile Build Server?

A. 1 and 3

B. 1 and 2

C. 2 and 3

D. 1, 2 and 3

What is the remote management option for G Series VxRail nodes?

A. RMM

B. iLO

C. iDRAC

D. IPMI/BMC

A company has a two chassis G Series cluster and wants to change the setup. This will require a reset of

the chassis.

What is the correct procedure?

A. Reset both chassis simultaneously through the reset script

B. Reset the primary chassis first, followed by the secondary chassis, through the reset script.

C. Reset both chassis simultaneously with the mobile build server

D. Reset the secondary chassis first, followed by the primary chassis, through the reset script.

What is a requirement for Top of Rack (ToR) switch VxRail node ports?

A. Enable Spanning Tree

B. Disable IGMP Snooping

C. Enable IGMP Querier

D. Disable Link Aggregation

When adding an S Series node to a Gen 2 VxRail 240F cluster the build fails. What could be a possible cause of this situation?

A. IP Pool has no more free addresses

B. Hybrid and Flash nodes cannot be mixed in the same cluster

C. Quanta and Dell hardware cannot be mixed in the same cluster

D. Loudmouth process needs to be restarted

What accurately describes VxRail G Series nodes?

A. All nodes in a chassis must be identical.

B. Different dot releases of the same major release are permitted if in different chassis.

C. Each chassis must be fully populated.

D. Hybrid and all-flash nodes are permitted if in different chassis.

In a VxRail external vCenter deployment, which component(s) are automatically licensed?

A. vCenter only

B. vCenter and vSAN

C. None

D. vSAN only

During a VxRail deployment validation check it is discovered that the Top of Rack (ToR) switches have Spanning Tree Protocol enabled. What should be done before the implementation can proceed?

A. Confirm that ToR switchports connected to VxRail nodes are configured to get into "forwarding" mode quickly.

B. Confirm that ToR switch ports connected to VxRail nodes have fabric-trunk enabled.

C. Disable STP on the ToR switches

D. Confirm that isolated VLANs exist on the ToRswitches for each of the VxRail networks.