Printable PDF
Want to pass your HCIE-Carrier IP (Written) V2.0 H31-161 exam in the very first attempt? Try Pass2lead! It is equally effective for both starters and IT professionals.
VCE
Exhibit.
As shown in the figure, RTA connects to RTB and RTC A TE tunnel is configure on RTA to reach RTC. The TE tunnel cannot be successfully established. However, CSPF-based calculation is successful and RTA does not receives any PathErro messages. What are possible causes?
A. An interface address on RTP is the same as the address of interface RTA-1.
B. RSVP-TE is not configured at interface RTB-2.
C. Different authentication keys are configured on interface RTB-2 and RTC-1.
D. The reserved bandwidth is insufficient at interface RTB-2
Which statement about the tunnel policy configuration is false?(A)
A. The tunnel policy is configured in the system view. You can run the tunnel-policy policy- name command to create tunnel policies and enter the tunnel policy view. One VPN instance supports multiple tunnel policies, and multiple VPN instances can share a tunnel policy.
B. You can run tunnel select-seq { gre | lsp | cr-lsp } * load-balance-number load-balance- number in the tunnel policy view to configure the priorities of tunnels and the number of tunnels among which load is balanced.
C. You can run the tnl-policy policy-name command in the VPN instance view to apply tunnel policies to VPN instances. If the required tunnel policy does not exist, the configuration is saved but does not take effect. If you create this tunnel policy in the system view later, the saved configuration will take effect.
D. If a VPN instance does not have a tunnel policy, an LSP is used and the number of tunnels configured for load balancing is set to 1
Refer to the exhibit.
As shown in the figure, RTA belongs to AS 100 and has an EBGP neighbor relationship with RTB. RTB, RTC, RTD, RTE, and RTF belong to AS 200.RTB, RTD, and RTE are assigned to AS65001, RTC to AS65002, and RTF to AS65003.
1.
When route 1.1.1.1/32 is imported from RTA, what is the AS_Path attribute of this route to be advertised to RTF?
2.
When route 1.1.1.1/32 is imported from RTC, what is the AS_Path attribute of this route to be advertised to RTA?
3.
When route 1.1.1.1/32 is imported from RTC, what is the AS_Path attribute of this route to be advertised to RTE?
The attributes are as follows:
A. (65001) 100; 200; (65002)
B. (65001) 200 100; (65002) (65001) 200; (65002)
C. (65003) (65001) 200 100; 200; 200
D. 100; 200; empty