Alarm suppression applies to intra-board alarms. When alarms of different severity levels are generated, the alarm of a higher severity level suppress the alarm of a lower severity level.
A. TRUE
B. FALSE
No fiber connections exist between three rings. The gateway NEs of the three rings are connected to the NMS using different network cables but through the same HUB. What can you do to isolate ECC communication between the gateway NEs?
A. Disable extended ECC on the three gateway NEs.
B. Disable the OSI protocol on the three gateway NEs.
C. Disable DCC access on the three gateway NEs.
D. Delete the DCC transparent transmission bytes on the three gateway NEs.
When the local end detects BER threshold-crossing in the receive direction, what performance events may be reported in the transmit direction of the peer end?
A. LPFEBBE
B. HPFEBBE
C. MSFEBBE
D. RSFEBBE
Which of the following is used to define the total number of frames received at line rate without packet loss?
A. Throughput
B. Latency
C. Packet loss rate
D. Back-to-back
The physical cross-connect board of an OSN 3500 is N1SXCSA. Which of the following can be configured as the logical board for N1SXCSA?
A. N1SXCSA
B. N1EXCSA
C. N1UXCSA
D. N2SXCSA
E. N2EXCSA
Latency of cut-through equipment is the difference between the time the first bit of a data frame enters the equipment and the time the first bit exits the equipment.
A. TRUE
B. FALSE
Two SNCP rings are tangent. How many SCNP protection groups must be configured on the tangent node to achieve protection for inter-ring services, assuming one fiber cut on two rings or one fiber cut per ring?
A. 2
B. 4
C. 6
D. 8
An N2SLQ16 board that is configured with AU3 services is faulty. If no spare N2SLQ16 board is available, the N1SLQ16 board can function as a substitute.
A. TRUE
B. FALSE
Which of the following are false about software installation on the PC that runs the NMS?
A. Ensure that anti-virus software is installed on the PC.
B. Game software can be installed after anti-virus software.
C. You can access the Internet on the PC.
D. Regular upgrade is not needed for the anti-virus software.
SDH equipment supports many protection types. Which of the following statements is false?
A. It is recommended that the working board be removed for a TPS test two minutes after TPS protection is configured, because it takes a period of time for the protocol to obtain the physical type of the processing board.
B. When 1+1 protection is configured for the power supply, each PIU board provides 50% of the required DC power. When one PIU board fails, the other also stops providing power.
C. The 1+1 protection switching between GSCC boards is non-revertive. Services can be switched back only by removing the working board or issuing a switching command on the U2000.
D. After you insert a GSCC board back, the working GSCC board needs to synchronize data to the newly inserted GSCC board. Wait 5 to 10 minutes until the synchronization is completed. Then restore board active/standby status.