You have a new cluster and must create a LIF on a port that uses LACP and VLAN. What is the correct order of network tasks that are required before you create the LIF?

A. ifgroup -> VLAN -> add port to broadcast domain

B. VLAN -> ifgroup -> add port to broadcast domain

C. add port to broadcast domain ?ifgroup >; VLAN

D. add port to broadcast domain -> VLAN -> ifgroup

Which two objects are supported in a FlexVol volume? (Choose two.)

A. gtree

B. LUN

C. RAID group

D. aggregate

A cluster is running ONTAP 9.3. You create a SnapMirror relationship and specify the type as DP and the policy as MirrorAIISnapshots. When you view the newly created relationship, you notice that the policy is MirrorAIISnapshots, but the type is XDP, not DP.

In this scenario, why is the type XDP instead of DP?

A. ONTAP 9.3 does not support DP.

B. The source NetApp cluster is running an older version of ONTAP.

C. ONTAP 9.3 defaults all new relationships to XDP.

D. The MirrorAIISnapshots policy is available only for XDP.

You want to enable jumbo frames for iSCSI traffic on your cluster. To satisfy this requirement, what would you modify on the cluster?

A. broadcast domains

B. igroups

C. iSCSI LIFs

D. network ports

You configure a new LUN on a NetApp cluster, and you can successfully access it from the host. An application using the new LUN is having storage performance problems, and ONTAP is reporting misalignment on the LUN.

In this scenario, what is causing the performance and misalignment problems?

A. The LUN was created with the incorrect OS type.

B. The host does not support ALUA.

C. The igroup is configured without Selective LUN Mapping (SLM).

D. The host is using a non-optimized SAN path.

Click the Exhibit button.

You have a 4-node NetApp SAN cluster configured as shown in the exhibit.

By default, how many LUN paths does the host see for a newly created LUN on Node 01?

A. 2

B. 1

C. 8

D. 4

Click the Exhibit button.

(missing the Exhibit)

Referring to the exhibit, what is a valid storage failover scenario?

A. Node 1 fails and Node 2 takes over Node 1's storage.

B. Node 2 fails and Node 3 takes over Node 2's storage.

C. Node 3 fails and Node 1 takes over Node 3's storage.

D. Node 4 fails and Node 2 takes over Node 4's storage.

You complete an installation of a FAS8200 that has two separate stacks of disk shelves. In this scenario, which NetApp tool should be used to validate the disk shelf cabling?

A. Config Advisor

B. OnCommand System Manager

C. OnCommand Unified Manager

D. Hardware Universe

Which two statements about replicating FlexGroup volumes are true? (Choose two.)

A. You can increase the capacity of a FlexGroup volume that is being replicated.

B. You cannot perform a resync on a FlexGroup SnapMirror relationship after it has been broken.

C. The SnapMirror relationship type must be XDP.

D. The SnapMirror relationship type must be DP.

Click the Exhibit button.

Referring to the exhibit, what is the throughput limit for the shares0 volume?

A. 250 IOPS

B. 25 MB/s

C. 50 MB/s

D. 1000 IOPS