Windows 2019 reports 500 GB of free space on a disk; however, on the storage side, the LUN has 0 bytes free. When the host deletes files on the disk, auto reclaim on the thin- provisioned LUN does not occur. In this scenario, which action should you take to enable space reclamation?

A. Set the space allocation option to disable.

B. Set the space allocation option to enable.

C. Enable space guarantees on the volume.

D. Enable space guarantees on the LUN.

You have created a new FlexCache cache volume and want to warm the cache before clients access the cache volume for the first time. In this scenario, how would you accomplish this task?

A. Prepopulate the cache volume with data from the origin volume using the flexcache prepopulate start command.

B. Enable block-level Invalidation using the volume flexcache origin config modify command.

C. Copy the data from the origin volume to the cache volume with the NetApp XCP Migration Tool.

D. Synchronize the origin and cache first with the volume flexcache sync-properties command.

A customer has a 2-node AFF A220 cluster and needs to enable the FC protocol. The onboard UTA2 ports are configured for 10Gbps Ethernet. In this scenario, what are two different methods to use FCP over the UTA2 ports? (Choose two.)

A. Swap the Ethernet transceivers in the UTA2 ports for 1Gbps transceivers, and configure the ports as target ports.

B. Connect onboard UTA2 ports to a Nexus switch and enable FCP.

C. Swap the Ethernet transceivers in the UTA2 ports for FC transceivers, and configure the ports as target ports.

D. Change the existing UTA2 ports from 10 Gbps speed to 8 Gb speed.

A company has three servers that are using the iSCSI protocol to connect to a 2 node NetApp ONTAP cluster. The server administrator notices that half of the paths are down. When you check the ONTAP cluster, you notice that the servers are togging into only the first controller.

Which two steps do you take to troubleshoot the issue? (Choose two.)

A. Verify that the UFs are up.

B. Verify that the ISCSI data protocol has been enabled on the ports.

C. Verify that each server has been rebooted.

D. Verify that the controller has not been taken over.

Your company runs a NetApp AFF A220 cluster as a file server for NFS and SMB. You want to use one of the unused ports to connect a single Windows host directly, using FC. You have converted the UTA2 ports e0e and e0f to FC and equipped them with a 16-Gbps FC transceiver. Your Windows host fails to connect to the storage.

In this scenario, which action solves the problem?

A. Use an FC switch between storage and host.

B. Use the arbitrated loop topology on storage and host.

C. Use the point-to-point topology on all ports.

D. Use an Ethernet switch between storage and host.

Which two types of capacity tiers are supported with FabricPool aggregates In ONTAP 9.8? (Choose two.)

A. SWIFT Object Store

B. NFS Export

C. StorageGRID Object Storage

D. S3 Object Store

You have commissioned a new AFF A250 MetroCluster over IP configuration. Your company requires an automatic switchover to the surviving site In case of a site disaster. What do you need to configure to fulfill this requirement?

A. cluster failover

B. ONTAP Mediator service

C. storage failover

D. automated unplanned switchover

After attempting to perform an ONTAP upgrade. It falls during the pre-check. In this scenario, what would cause this problem?

A. encrypted volumes

B. offline volume

C. Idle SnapMirrors

D. offline data LIF

Your company requires WORM archiving of data on their ONTAP cluster. The data must not be able to be deleted even by an administrator. Which ONTAP feature fulfills this requirement?

A. SnapLock Compliance

B. SnapMlrror software

C. SnapLock Enterprise

D. SnapVault software

Which two storage efficiency features are enabled by default on AFF systems? (Choose two.)

A. LUN-level compression

B. aggregate-level compression

C. aggregate-level inline deduplication

D. volume-level Inline deduplication