Your customer wants to buy four new DS212C shelves with an 8 TB SATA drive. The customer also wants to know the usable aggregate size of this configuration.

In this scenario, which resource would you use to accomplish this task?

A. Fusion

B. Hardware Universe (HWU)

C. Interoperability Matrix Tool (IMT)

D. Config Advisor

You install and apply the NetApp RSCF on cluster interconnect switches.

Which two statements are correct in this scenario? (Choose two.)

A. The RCF file enables jumbo frames for all cluster traffic.

B. The RCF file enables IPv6 for use by the cluster traffic.

C. The RCF file enables flow control and is set to receive.

D. The RCF file enables CDP to allow connected devices to discover the switch.

A node joins a cluster in ONTAP 9.5.

Which statement is correct about the NTP configuration in this situation?

A. A node that joins a cluster must reboot before running the NTP service.

B. A node that join a cluster has a separate NTP service.

C. A node that joins a cluster must be manually configured for NTP.

D. A node that joins a cluster automatically adopts the NTP configuration of the cluster

Which two NetApp features encrypt storage data? (Choose two.)

A. NVE

B. NSE

C. TPM

D. NVMe

You just finished an AFF A300 installation with two DS224C disk shelves. What are two ways to cable these disk shelves? (Choose two.)

A. Use alternative control path.

B. Use single-path HA.

C. Use quad-path HA.

D. Use multipath HA.

An iSCSI LIF fails to migrate during a storage failover test. In this scenario, why did the LIF not migrate?

A. A failover port was not defined.

B. LIFs that serve block protocols do not failover.

C. The failover policy was not configured.

D. LIF failover was not enabled.

A customer wants to expand a 10-node AFF A700s NAS cluster running with Cisco Nexus 3132Q-V cluster interconnect switches using new nodes.

In this scenario, what is the maximum number of nodes to be added into this cluster?

A. 24

B. 2

C. 12

D. 14

You have just installed a new AFF A220 4-node cluster with ONTAP 9.5 for a customer. Which two cluster switches are supported in this scenario? (Choose two.)

A. Cisco Nexus 5596UP

B. Brocade 6510

C. Cisco MDS 91485

D. NetApp CN1610

A customer wants to reduce the task allocation requirement for the root aggregate and increase usable storage by partitioning the disks into one large part and one small part. The small part is used for the root aggregate and the large part for the data aggregates?

In this situation, what is this feature called?

A. ONTAP

B. RAID

C. storage virtual machine

D. Advanced Drive Partitioning

What is a node?

A. A node refers to all physical devices bound together In the cluster.

B. A node is the logical device that shares data.

C. A node is a logical network port.

D. A node is a controller that is part of the cluster.