What should you do to confirm a component failure prior to replacing hardware? (Choose the best answer.)

A. Run the Recovery Guru

B. Run chkdsk on the client

C. Check the Major Events Log

D. Power cycle the storage array

What system file is used during the controller start-of-day sequence to determine various SCSI parameters and other host-type specific settings for an E-Series system? (Choose the best answer.)

A. Major Event Log

B. ESM Firmware

C. NVSRAM

D. Unreadable Sectors Log

The system automatically disables write caching when _________. (Choose the best answer.)

A. a disk pool is being expanded by adding a drive

B. a failed disk drive has put a volume group into a degraded state

C. there is a failed controller on the system, so that cache mirroring is unavailable

D. the systemdetects a small percentage of cache hits over a 10-minute timeframe

E. more than 4 unique host identifiers are trying to access the same volume

What is the `base' host connectivity provided by the E2600 controller? (Choose the best answer.)

A. None

B. IB

C. iSCSI

D. SAS

E. FC

Schedules for AutoSupport's periodic collection of data can be changed in the ________. (Choose the best answer.)

A. NVSRAM

B. Major Event Log

C. Enterprise Management Window

D. Array Management Window

Which storage manager feature scans the system for issues, reports them, and suggests procedures that will correct the issue?

A. Recovery guru

B. Event Log

C. Diagmon

D. Performance monitor

E. Storage array diagnostics

On all the drives, which reserved region stores configuration information? (Choose the best answer.)

A. Volume header

B. Partition table

C. Disk label

D. DACstore

E. NVSRAM

What does the storage system use to preserve cache data in the event of a complete controller failure? (Choose the best answer.)

A. Cache mirroring

B. Flash read cache

C. Pre-fetch caching

D. Read caching

E. Write caching

What is the `base' host connectivity provided by the E5500 Controller? (Choose the best answer.)

A. IB

B. SAS

C. FC

D. iSCSI

E. None

Review the diagram.

Is this cabling correct or incorrect, and why? (Choose the best answer.)

A. The cabling is incorrect because the controllers are cabled from the host port.

B. The cabling is incorrect because it usesthe top-down bottom-up cabling method.

C. The cabling is correct because it follows the recommended E-Series cabling method.

D. The cabling is incorrect because they have been daisy-chained.