NetApp Certified Implementation Engineer - SAN Specialist, E-Series: NS0-515

Your company has an E-Series system connected to Cisco MDS switches. You are asked to provision a volume on a new Windows host, but the Windows host is unable to connect to the volume on the E-Series system. All other Windows hosts in the fabric are able to connect to their volumes.

In this scenario, which three actions should you perform to accomplish this task? (Choose three.)

A. Create a new virtual SAN (VSAN)

B. Obtain the WWPN for the Windows HBA

C. Restart the switches

D. Create a single-initiator zone with the host and E-Series system

E. Add a zone to the active zoneset

What are two methods for setting the host protocol configuration on the E2800 controller with a 4-port 16Gbps FC or 10Gbps iSCSI SFP+ host interface card (HIC)? (Choose two.)

A. Set at the factory, based on the order

B. Change the QSFP type in the HIC

C. Change the Feature Pack in the SANtricity System Manager

D. Set in the Hardware tab using SANtricity System Manager

An administrator is asked to provision a 1 TB volume to hold non-critical temporary data for a seismic-analysis application. The volume requires the highest possible IOPS.

In this scenario, which configuration would satisfy this requirement?

A. RAID 6 Dynamic Disk Pool with a 256 KiB segment size

B. RAID 5 volume group with a 256 KiB segment size

C. RAID 0 volume group with a 32 KiB segment size

D. RAID 6 Dynamic Disk Pool with a 32 KiB segment size