Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)

A. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.

B. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.

C. DARRP measurements can be scheduled to occur at specific times.

D. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.

Which factor is the best indicator of wireless client connection quality?

A. Downstream link rate, the connection rate for the AP to the client

B. The receive signal strength (RSS) of the client at the AP

C. Upstream link rate, the connection rate for the client to the AP

D. The channel utilization of the channel the client is using

Which two statements about background rogue scanning are correct? (Choose two.)

A. A dedicated radio configured for background scanning can support the connection of wireless clients

B. When detecting rogue APs, a dedicated radio configured for background scanning can suppress the rogue AP

C. Background rogue scanning requires DARRP to be enabled on the AP instance

D. A dedicated radio configured for background scanning can detect rogue devices on all other channels in its configured frequency band.

As standard best practice, which configuration should be performed before configuring FortiAPs using a FortiGate wireless controller?

A. Create wireless LAN specific policies

B. Preauthorize APs

C. Create a custom AP profile

D. Set the wireless controller country setting

When using FortiPresence as a captive portal, which two types of public authentication services can be used to access guest Wi-Fi? (Choose two.)

A. Social networks authentication

B. Software security token authentication

C. Short message service authentication

D. Hardware security token authentication

Six APs are located in a remotely based branch office and are managed by a centrally hosted FortiGate. Multiple wireless users frequently connect and roam between the APs in the remote office.

The network they connect to, is secured with WPA2-PSK. As currently configured, the WAN connection between the branch office and the centrally hosted FortiGate is unreliable.

Which configuration would enable the most reliable wireless connectivity for the remote clients?

A. Configure a tunnel mode wireless network and enable split tunneling to the local network

B. Configure a bridge mode wireless network and enable the Local standalone configuration option

C. Configure a bridge mode wireless network and enable the Local authentication configuration option

D. Install supported FortiAP and configure a bridge mode wireless network

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

A. Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility

B. Areas with the signal strength weaker than -68 dB are cut out of the map

C. Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor

D. Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.

Which of the following is a requirement to generate analytic reports using on-site FortiPresence deployment?

A. SQL services must be running

B. Two wireless APs must be sending data

C. DTLS encryption on wireless traffic must be turned off

D. Wireless network security must be set to open

A tunnel mode wireless network is configured on a FortiGate wireless controller. Which task must be completed before the wireless network can be used?

A. The wireless network interface must be assigned a Layer 3 address

B. Security Fabric and HTTPS must be enabled on the wireless network interface

C. The wireless network to Internet firewall policy must be configured

D. The new network must be manually assigned to a FortiAP profile

Which statement is correct about security profiles on FortiAP devices?

A. Security profiles on FortiAP devices can use FortiGate subscription to inspect the traffic

B. Only bridge mode SSIDs can apply the security profiles

C. Disable DTLS on FortiAP

D. FortiGate performs inspection the wireless traffic