When Incorporating Split Multi-Link Trunk (SMLT) on a pair of Ethernet Routing Switch (ERS) 8600 switches traffic from the edge of the network is directed to

either ERS 8600. The ping-snoop feature assists in determining which path the traffic is taking.

How does the ping-snoop operation work?

A. Ping snoop requires configuration changes to the edge devices.

B. Ping snoop looks at the MAC header and directs traffic to the designated link.

C. Ping snoop identifies traffic that matches the IP flow specified in the ping snoop command.

D. Ping snoop configurations are saved and can be configured to restart automatically after a reboot.

To provide load distribution across two or more equal cost paths in a Layer 3 routing environment, the ECMP feature can be used to maximize load sharing. Which two statements correctly describe the ECMP features? (Choose two)

A. All ECMP next hop addresses are in the routing table

B. ECMP keeps traffic between two IP addresses on one single path.

C. All ECMP paths are active and forwarding traffic.

D. ECMP routes apply to OSPF, RIP and BGP only.

Which protocol can be used for end-to-end detection in a network as well as for point-to-point detection?

A. LACP

B. VLACP

C. RSTP

D. MSTP

Not long after bootup of an upgraded Ethernet Routing Switch (ERS) 8310, the system hangs. Which statement describes the cause of this problem?

A. The CPU module was configured in slot 5.

B. An ERS 8600 module was configured in the 8300 chassis

C. The system includes dual 839xSF modules

D. The system was running in full duplex mode.

Routed Split Multi-Link Trunking (RSMLT) is a way to ensure that traffic can be routed off the VLAN adding router redundancy. On which Ethernet Routing Switch (ERS) configuration component is RSMLT configured?

A. an OSPF protocol

B. a core switch port

C. a VLAN

D. an MLT

A campus network has been established with four Ethernet Routing Switch (ERS) 8600 switches in a switch cluster, two pairs with an Inter Switch Trunks (1ST)

running Split Multi-Link Trunk (SMLT) and Routed Split Multi-Link Trunking (RSMLT). The traffic filters are required to block specific source IP addresses to be

forwarded through the core.

How should these filters be set up?

A. Configure the filters on the 1ST first before any other ports.

B. Apply the filters to all ports that receive traffic from outside the immediate switch cluster.

C. Configure the filters on the ports first and then the 1ST.

D. Apply the filters to the edge switches and never on the switch cluster ERS 8600 switches.

A technician is implementing a new network that contains eight Ethernet routing switch (ERS) 8600 switches and uses advanced features. Where are two possibilities for generating license? (Choose two)

A. one individual advanced feature license for each ERS 8600 chassis

B. one multi-chassis license using multiple MAC addresses

C. one advanced feature license for the network

D. one premier feature license for the network

E. one site license per ERS 8600

With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features. Which two statements ant true about the Advanced Routing License process and supported features for the ERS 8300? (Choose two.)

A. the Advanced Routing License supports QoS, SMLT, VRRP and OSPF

B. the Advanced Routing License supports SMLT, VRRP, OSPF, PIM-SM. and SLPP

C. To protect against security breaches, the ERS 8300 allows only a primary path for the license file

D. To protect against system flash failure, the ERS 8300 allows a primary, secondary, and tertiary path for the license file.

In Ethernet Routing Switch (ERS) 5600 switch was added into the existing ERS 5500 stack, but ft did not form a proper stack. Which statement describes the problem?

A. The ERS 5600 was set as the Base Unit.

B. The stack was reset for a change in Base Unit to take effect.

C. The mode parameter on the ERS 5600 switch was set to Mixed Mode.

D. The ERS 5500 was set as the Base Unit.

When configuring an Ethernet Routing Switch (ERS) 8600 for Split Multi link Trunking (SMLT). Protection against an edge switch in the factory default condition must be taken into consideration. Which parameter WILL help prevent loops on the SMLT ports?

A. Discard Untagged Frames

B. Discard Looped Frames

C. Spanning Tree Enable

D. LACP Enable