Want to pass your Avaya ERS 8000 and Avaya VSP 9000 Implementation Exam 6103 exam in the very first attempt? Try Pass2lead! It is equally effective for both starters and IT professionals.
VCE
The attempt to manage an Ethernet Routing Switch (ERS) 8000 using a VRRP address was unsuccessful. What is causing this problem?
A. The virtual router identifier is 0.
B. The datacenter interface is set as a critical IP interface.
C. A real IP address is required for management access not a VRRP address.
D. The incorrect MAC offset is configured for the VRRP address.
Refer to the exhibit.
Simple Loop Prevention Protocol (SLPP) provides active protection against Layer 2 network loops on a per-VLAN basis. For the SLPP Tx process, the network administrator decides on which VLANs to enable SLPP. The hello packets are then replicated out all ports that are members of the SLPP-enabled VLAN.
Given the following information shown in the exhibit: A = InterSwitch Trunk (IST) B = Split MultiLink Trunk (SMLT) # 1 VSP 9000 # 2 VSP 9000 # 3 ERS 4500
When setting up the SLPP Rx process, which configuration role is setup on VSP #1?
A. The VSP #1 Rx process is enabled on all SMLT VLANs to monitor for the ERS #3 SLPP packets.
B. The VSP #1 Rx process is enabled on port 3/1 and the IST ports to monitor for the VSP #2 SLPP packets.
C. The VSP # 1 Rx process is enabled on all SMLT VLANs to monitor for the VSP # 2 SLPP packets.
D. The VSP # 1 RX process is enabled on port 3/1 to monitor VSP # 1 and VSP #2 SLPP packets.
When configuring an Ethernet Routing Switch (ERS) 8000 for Split Multi Link Trunking (SMLT), protection against an edge switch in the factory default condition must be taken into consideration.
Which parameter will help prevent loops on the SMLT ports?
A. Enable SLPP.
B. Discard Looped Frames.
C. Enable Spanning Tree.
D. Enable LACP.