Building HP FlexFabric Data Centers: HP2-Z34

Refer to the exhibit An administrator is setting up this data center topology to use SPBM VMs in the same subnet should be able to communicate at Layer 2 and be isolated at Layer 2 from other subnets. On which Switch 1 interfaces should the administrator enable SPBM?

A. interfaces Ten1/0/1-Ten1/0/48 and interfaces Forty1/0749-1/0750

B. interfaces Forty 1/0749-1/075 only

C. VLAN interfaces 101 and 103

D. VLAN interfaces 10, 20, and 30

Which statement is correct about a Fibre Channel (FC) World Wide Name (WWN)?

A. It is a hardware specific address for a LUN on a storage disk and can be used to direct FC frames to targets.

B. It is a hardware specific address for an FC device and can be used to place the device in zones.

C. It is assigned to an FC device based on its location and can be used to deliver FC frames

D. It is assigned to an FC N-port as its switch joins the fabric and can be used to route FC frames

Refer to the exhibit A VSAN is being set up on an HP Comware switch that will connect to server Converged Network Adapters (CNAs) and storage systems The administrator is checking the configuration of the VSAN with display commands The exhibit shows the results.

What is a potential issue?

A. The current zoning configuration does not permit any communication.

B. The fabric name has been set to the same ID as the switch WWN. which causes conflicts.

C. The distribute mode for zones has been set to active only, which can cause issues with redundancy.

D. The domain ID has been set manually to a preferred ID, but this switch does not have the highest priority