Want to pass your Designing Aruba Solutions HPE6-A47 exam in the very first attempt? Try Pass2lead! It is equally effective for both starters and IT professionals.
VCE
Refer to the exhibit.

The customer needs to expand its wired and wireless network to a new building, Building 2, which is near the existing building, Building 1. The exhibit shows the logical plan that the architect has created so far. The aggregation layer switches in the new building should provide the default gateway services for the VLANs in the new building and route traffic to the core. The existing Aruba Mobility Controllers (MCs) will control the new APs.
What should be the VLAN assignment for Link 1, indicated in the exhibit?
A. an unused VLAN such as 200
B. VLANs 21, 22, and 23 only
C. VLANs 11, 12, 13, 21, 22, and 23
D. the default VLAN and VLAN 14
Refer to the exhibit.

The exhibit shows the current plan for a wired network upgrade.
As much as possible, the customer wants to flatten the architecture and avoid recabling. However, each Building 2 switch must also maintain connectivity to the core if one link fails.
What should the architect propose to meet the customer requirements?
A. Use two additional 2930F switches to act as an aggregation layer for Building 2; connect them to the core on 40 GbE connections.
B. Connect each Building 2 switch directly to the core on a single fiber strand through the use of SFP+-SR transceivers.
C. Combine the switches in each Building 2 closet as a VSF fabric; establish two 10 GbE connections to the core per fabric.
D. Extend additional fiber between the buildings so that each Building 2 switch can have a direct 10 GbE connection to the core.
An architect plans where to deploy new Aruba 320 Series APs at a customer site. The architect plans for the APs to be installed on the ceiling where power is inaccessible. The Ethernet cable run to these locations is CAT6, and the customer wants to support at least 1 GbE connectivity. The architect plans to connect each AP with one Ethernet port to a switch in a nearby wiring closet.
Which feature does the switch need to support for this deployment?
A. PoE+
B. LACP
C. Port channel
D. Smart Rate