NetApp Certified Support Engineer: NS0-192

A customer explains that the Active IQ section of the NetApp Support site indicates that their controller has not called home within the past three months. They are not using a mail host to deliver AutoSupport notifications. When troubleshooting the AutoSupport message, you enter the event log show messagename asup.post* command.

In this scenario, what would you expect to see on the console?

A. event-management system (EMS) events for the AutoSupport system that are related to SMTP

B. a history of all error events related to the AutoSupport system

C. event-management system (EMS) events for the AutoSupport system that are related to HTTP/HTTPS

D. event-management (EMS) events for the AutoSupport system that are related to any protocol

A customer performed maintenance last weekend and power cycled both FAS8060 nodes of a 2-node ONTAP 9.2 cluster. The customer is concerned about port errors seen from the system ha interconnect port show command output.

Which two steps would you perform in troubleshooting this condition? (Choose two.)

A. Use the system ha interconnect link off/on command to manually reset the HA interconnect Link 0 and Link 1 on both nodes.

B. Perform a takeover/giveback of both nodes.

C. reset the counters using the system ha interconnect statistics clear-port command.

D. Use the system ha interconnect flush command to manually reset the HA interconnect Link 0 and Link 1 on both nodes.

After replacing a failed disk, the disk does not appear as a spare on any node in the cluster.

What should be done to correct this problem?

A. Physically remove the disk and re-seat it firmly in the storage bay.

B. Physically remove and re-seat each IOM in the shelf, one at a time.

C. Assign ownership of the replaced disk to a node.

D. Add the disk into an aggregate on either node.