Certified Wireless Design Professional: CWDP-304

After designing a WLAN infrastructure using predictive design software. What's the best way to validate the predictive design in the physical space before deployment, if time and budget allow for it?

A. Deploy all of the APs as they're shown in the predictive design and perform an active sitesurvey.

B. Deploy all of the APs as they're shown in the predictive design and perform a passive site survey.

C. Use a client device positioned where the APs will be installed and measure the signal from the client device.

D. Perform an AP-on-a-Stick survey using AP locations based upon the predictive design to confirm each AP's placement.

While performing a validation site survey, you realize that overlapping channels are being used on the 2.4 GHz bad due to the automatic channel assignment algorithm of the WLAN infrastructure. What should you do to prevent this?

A. Reconfigure the automatic channel assignment settings to use only channels 1, 6, and

B. Purchase and deploy new APs from a different vendor

C. Reconfigure the network to use static channel plans because automatic channel assignment algorithms are all broken

D. Leave it as it is; sometimes using all 11 channels in 2.4 GHz gives the optimum performance result

A wireless network with fewer APs at higher power levels to cover a large area is said to be which of the following?

Response:

A. Capacity based

B. Coverage based

C. Destined for failure

D. Ideal for roaming